Problem: Finish is too sticky or tacky.
|
| Cause | Solution |
| Finish is applied too thick | Apply thin coats and allow each to
dry before applying the next coat. |
Not enough drying time between
coats. | Under normal conditions finishes
dry in 20-30 minutes. High humidity
extends drying time. |
Restorer not properly diluted or
applied too frequently. | Follow label instructions. Under-
diluting or overuse can leave a
sticky residue. |
Restorer / maintainer not burnished
soon enough after application. | When dry, restorer/maintainer will
continue to soften finish if not
burnished.
|
Floor not properly rinsed before
application of finish. | Thoroughly rinse and neutralize
floor after stripping. Use neutral
cleaner in proper dilution. |
| Improper use of disinfectants. | Measure carefully and follow label
directions. |
| Separation of finish. | Finish may have been exposed to
prolonged heat causing separation
in the product. Shake or stir before
using. |
Problem: Finish swirls or scratches
|
| Cause | Solution |
| Pad is too aggressive. | Use the recommended pad for a
particular task whether it be
burnishing or cleaning. |
| Pad is dirty. | Clean with a wire brush or put pad
in deep sink and spray off the build-
up. Hang up to dry. |
| Floor is dirty or sandy. | Use walk-off mats; dust thoroughly
before burnishing. |
mail@tepesanitary.com
with questions or comments about this site.